SleepSafe Beds Dreama RETROFIT KIT Quick Start Manual

RETROFIT KIT
How to install a Dreama
Includes: Dreama 24hr Positioning System; Deck Pad; Deck Strap; Deck Screws
TM
Tools Needed: 4mm Allen Wrench (Included) or Drill with 4mm Allen Bit
Loosen
Screw
EXCESS STRAP
USED TO SECURE
DREAMA TO BED
STRAP IS FED BENEATH THIS DECK PANEL
EXCESS STRAP
System into a SleepSafe® Bed
TM
HEADBOARD
Remove Screw
Loosen
Screw
Loosen Screw
PLACE PAD
ON TOP OF
THE DECK.
3629 Reed Creek Dr. / Bassett, VA 24055
Toll Free: 866.852.2337
SleepSafeBed.com
sleepsafebed@sleepsafebed.com

LOWER SAFETY RAILS.
REMOVE MATTRESS.
LOOSEN 3 SCREWS, REMOVE 1
IN THE 2ND BED DECK PANEL.
With 4mm Allen Wrench (or drill with bit),
loosen 3 screws and remove 1 in the deck
panel as shown. The purpose is to allow
room to feed the strap beneath the deck.
FEED THE STRAP BENEATH

BOTH SIDES OF THE DECK PANEL.
Feed the strap beneath the deck. The buckle
should line up with the loosened screw.
Once buckle in place, replace removed screw,
and then tighten all the screws.
BUCKLE
POSITION ON DECK
LOOSENED
SCREW

PLACE PAD ON TOP OF DECK
INSIDE THE SLEEPSAFE BED.
PLACE PAD
ON TO THE DECK.
BUCK LE
POSITION ON
PAD
Note the position
of the strap
buckle once the
pad is placed on
top of the deck.