Section 2: Installation; Removal Of Transportation Screws - Philco PLD 1471 User Manual

SECTION 2: INSTALLATION

You must pay attention to the following issues before using your washing machine.

REMOVAL OF TRANSPORTATION SCREWS

• Transportation screws, which are located at the back side of the machine, must be removed before running
the machine.
• Loosen the screws by rotating counterclockwise by a suitable wrench. (DIAGRAM-1)
• Remove the screws by pulling them. (DIAGRAM-2)
• To the holes where the transport screws have been removed, insert the plastic transport screw taps found
in the accessories bag. (DIAGRAM-3)
• The transportation screws, that have been removed from the machine should be kept in hand for any
other transportation necessities.
NOTE:
Defects caused by running the washing machine with installed transportation screws, are not subject to
warranty.
DIAGRAM - 1
EN - 4
Copyright © 2011, Fast ČR, a. s.
DIAGRAM - 2 DIAGRAM - 3
02/2011