Chapter-3: Installation; Removing Transportation Safety Screws; Adjusting Adjustable Stays - Philco PLDA 1273 Chiva User Manual

Table of Contents

CHAPTER -3: INSTALLATION

Before operating the washing machine, remove the 4 transportation screws and

rubber spacers from the back of the machine. If the screws are not removed, it may

cause heavy vibration, noise and product malfunction, (voiding the guarantee).

For this reason, transportation safety screws shall be loosened by being

rotated in counter-clockwise using an appropriate wrench.

Transportation screws shall be removed by pulling out.

Fit the plastic transportation screw taps delivered in accessories bag to the palces

where transportation screws have been removed.

The transportation safety screws should be stored to be used in case of transportation.

NOTE: You should absolutely remove the transportation screws

of your machine before the first usage. Faults occurring in the

machines operated with transportation screw fitted shall be out

of scope of warranty.

• Do not install your machine on a carpet or such grounds

that would prevent the ventilation of its base.

• To ensure silent and vibration-free operation of your ma

chine, it should be deployed on a non-sliding and firm ground.

• You can adjust the balance of your machine through the stays.

• Loosen the plastic adjustment nut.

• Adjust the stays upward and downward by rotating them.

• After maintaining the balance, compress the plastic adjustment

nut upward again.

• Never put cardboard, wood or suchlike materials under

your machine if you are intending to stabilize the distor-

tions on the ground.

• When cleaning the ground, on which your machine rests,

be careful not to disorder stays stabilization.

Table of Contents