Installing Circuit Packs - ABB GPS2436 User Manual

Installing Circuit Packs

Modem
Modem Card
The optional Modem card may require field installation. To do so, perform the following steps:
Step
NOTE: Installation or replacement of this pack can be done "hot"; power removal is not necessary.
1. Remove the controller front cover.
2. Install the BSM on the 4 standoffs, to left of the controller MCR1 board using four 845143866 screws.
3. Connect the 848091798 cable assembly between the BSM J100 plug and P201 on the MCR1 board.
NOTE: This step may be performed at a later time
Install phone line wiring from Connect the existing telephone cable to the RJ11 connector at the top of the board
4.
OR Connect Tip/Ring conductors to TB1 at the top of the board.
NOTE: Tip is TB1 pin 1 (Pin closest to the RJ11 connector) and Ring is Pin 3. Pin 2 is not used.
5. Operate the reset switch on the MCR1 board in the lower left corner of the MCR1 board. (see Figure 4-3)
The Password Reset button is to the LEFT of the serial port connector, and the Controller Reset is to the right of
NOTE:
the serial connector.
Data Switch Card
Step
NOTE: Installation or replacement of this pack can be done "hot"; power removal is not necessary.
Install two 407882133 standoffs on the BSJ intelligent board. Screw threads are protruding just below TB1,
2.
located at the upper left hand corner of the MCR1 board.
3. Place BSW pack inside the 847950938 insulator.
4. Plug BSW pack into the P205 connector on the BSJ intelligent controller board
5. Secure the BSW board to the standoffs with two 900562208 screws.
To install the Data Switch Extension board, please see the User's Guide for Millennium II Controller Advanced
NOTE:
Features manual.
Page 34
© Copyright 2023 ABB. All rights reserved.
Modem Connector
Data switch
Reset Switch
Local Port
Figure 9-3: Millennium II Controller Connections
Rectifier Cable Connector
Gateway Connector
Action
Action
GPS2436_MAN
Fuses
Alarm Block
P6: Power
P1: LCD Connector
Rev. 1.3