ABB GPS2436 User Manual page 52

Default Display
The default display shown in figure 4-8 provides basic system status. The controller returns to this
display after approximately three minutes after the last time a key is pressed.
The first line shows:
# of Alarms
The larger text in the middle of the screen shows:
Plant Voltage
The bottom line(s) show:
An Hourglass may appear in the lower left hand corner of the screen. This indicates that a configuration change is being
saved to non-volatile memory.
Audible Alarm Cutoff State(Toggle)
(Only shown if an alarm is active)
Plant Mode (Default Float)
Screen information is updated approximately every two seconds. The front panel display offers a
series of menus that allow the user to:
• Configure
• Control
• View Status
• View History
• View Statistics
•
Perform Diagnostics
These menu operations are accomplished by navigating through different screens.
Page 52
© Copyright 2023 ABB. All rights reserved.
Figure 9-8: Millennium II Controller Default Display
# of Warnings
GPS2436_MAN
Date
Plant Load (Current)
Time
Rev. 1.3