Menu Overview - KERN EOC 30K-4S Operating Manual

8.2 Menu overview

Menu block Menu item
Main menu Submenu
PO CHK nEt H
Weighing with
tolerance range,
nEt L
see chap. 7.8
PCS H
PCS L
BEEP
A2n0
P1 rEF
Zero point settings
0AUto
0rAGE
0tArE
MODE
P2 COM
Interface
parameters
EOC-BA-e-1920
Available settings / explanation
Upper limit value „Tolerance check weighing",
input see chap. 7.8.1
Lower limit value „Tolerance check weighing",
input see chap. 7.8.1
Upper limit value „Tolerance check counting",
input see chap. 7.8.2
Lower limit value „Tolerance check counting",
input see chap. 7.8.2
Acoustic signal for weighing with tolerance range
no
switched off
ok Audio sound when load is within tolerance limits
Audio sound when load is beyond tolerance
nG
limits
Automatic zero point correction (Autozero) by changing the
display, digits selectable (0.5d, 1d, 2d, 4d)
Zero setting range
Load range where the display after switching-on the balance
is set to zero. Selectable 0, 2, 5, 10, 20, 30, 50, 100 %
Zero setting range
Load range where the display is set to zero by pressing
.
Selectable 0, 2, 4, 10, 20* , 50, 100%.
Automatic taring „on / off", taring range adjustable in menu
item „0Auto".
S0 off
CONT
S0 on
One output for stable weighing value
ST1
Continuous data output of stable weighing values
STC
PR1
Output after pressing
Manual totalizing, see chap. 7.9.
PR2
Press
added to the summation memory and issued.
Continuous data output,
selectable „sending 0", yes / no
and the weighing value will be
43