Table of Contents
Advertisement
Idle.timer
Option Values: 0.0 (off), .05 - 12.75 (seconds)
Applicable Data Protocols: X.25, Mode 3, BV64I, and BV56I
When the Data Mode is set to X.25, Mode 3, BV56I or BV64I, the ADM sends data through the
network in packets. If the time between characters exceeds the idle.timer, less than the full
packet will be sent out.
Interaction with Min.timer: An Idle.timer value greater than .05 seconds takes precedence over
the Min.timer.
Line.erase
Option Values: cancel
NAK
-
, @, off
Ctrl
U
Applicable Data Protocols: X.25, Mode 3, BV64I, and BV56I
This option allows you to choose the character that erases the entire contents of the
editing buffer.
Like Char.erase, Line.erase is enabled only when Edit is enabled. Select the character that best
meets your needs. If you do not have
and press
CONTROL
The Line.erase character is not sent out in the data packet.
Local.cr
Option Values: Any ASCII character except NUL, SOH,
-
,
Ctrl
U
Ctrl
Applicable Data Protocols: N/A
This option selects the Local Mode command line termination character. Some PC
communications packages access this option from the AT Local Mode. Individual users should
not change this option value.
Unlike most data options, Local.cr is an unstored option (it is not stored in a programmable
profile), and its setting reverts to the factory default value upon power-up.
4-8
Data Options and Profiles
-
,
Ctrl
X
CANCEL
. To use NAK, hold down
X
-
, BS (default = CR)
S
on your data terminal, you can hold down
and press
CONTROL
-
Ctrl
.
U
,
X
Advertisement
Table of Contents
