Table of Contents
Advertisement
Chapter 4, ''Data Options and Profiles'' for more information. To exit AT local
mode and return to the CMD local mode, type: at&&t . Refer to the Changing from
AT Local Mode to CMD Local Mode section in Chapter 3, ''Using the CMD and
AT Commands'' for more information.
At the CMD: prompt, type dial and the telephone number.
2
For example, type dial 5552222 .
Note:
When dialing, type: dial ; then one (and only one) space; then the number. Strict
adherence to this format is necessary. For example, typing dial , two spaces, and
the string results in the second space being transmitted as the first character in the
dialed string.
Press
. The response of the ADM will be similar to what is shown below.
3
RETURN
CALLING 555 2222
Type E to end call:
Supplementary circuit switched data features may require the entry of additional dialing
information prior to the receipt of the CONNECT message. To facilitate the use of these
features, the ADM allows you to enter additional dial commands before the CONNECT
message. Depending upon the network's response to the initial dialed digits, you may or
may not receive a CONTINUE message after the initial dial command.
Additional information may appear on your screen, such as:
CONNECT - MODE 2
FAR END SPEED - 9600
OR
CONNECT
DATA MODE
Once you see the CONNECT message, you should ignore the Type E to end call until
you end the session.
You are now ready to communicate with the far end. Enter data to be transmitted.
To end a data call, do one of the following:
4
press
DATA/SEND/OFF
OR
rapidly type the Attention sequence: +++ (see the description of the Attention option in
Chapter 4, ''Data Options and Profiles'').
The CMD: prompt is displayed.
Type e or end to end the call.
To redial the last data call, at the CMD: prompt, type redial followed by
5
2-6
Getting Started
.
RETURN
Advertisement
Table of Contents
