Maintenance - Flash 1107M Manual

GB
Wheels (4.00-8) with adjustable track
(35-40-45-50 cm)
These wheels have hexagonal axle holes and a hub
with two through holes.
To adjust track width, fit wheel
hub (4) by means of pin
gives the desired width.
For wide track settings, use spacer (3) between hub
and wheel. Track can be further widened by about 5
cm by reversing the wheels
rim on the inside).
In this case, however,
right wheels over to keep wheel tread pointing
right direction.
Wheels (4.00-10) with adjustable track
These wheels have removable flanges and a hub with
three through holes. To adjust
20/4, item 3) to wheel (1)
Then fit the wheel to the hub
(2) at the holes giving the required track width
ous settings are possible). With wide track settings,
use spacer (5) between hub and wheel. Further ad-
justment can be obtained by reversing and switching
the wheels as instructed

MAINTENANCE

To ensure continuing reliability,
parts when overhauling or repairing your two- wheel
tractor.
ENGINE
Make sure you do comply
contained in the engine Operation and Maintenance
Manual.
During the first 50 hours (running in)
For the first 50 hours do not use the machine for
heavy duty work.
The following additional instructions must also be
complied with during the running in period.
DRY TYPE AIR FILTER (HONDA GX 200)
Every 8 working hour
Carefully clean the air filter cartridge with air com-
pressed and in case of any damage substitute with
new one
OIL BATH AIR FILTER
(HONDA L 70 LOMBARDINI 1 IM 359
15 LD 315 HONDA GX160)
Every 8 hours
Check the oil level in the air filter.
with engine oil.
Clean the filter element as instructed in the engine
Operation and Maintenance Manual.
(fig. 20/3, item
(2) at the through hole which
(with the outside of
you must switch the left
track, first fit flange (fig.
with the four screws (4).
(6) and secure with pin
above.
use only original spare
with the safety precautions
/
If necessary, top up
Filter cleaning frequency depends on operating con-
ditions, but should never be more than 8 hours.
Every 60 hours
1) to
Clean the filter
instructed in
Manual.
GEARBOX AND TRANSMISSION
the
After the first 50 hours
and
Change the
in the
Change the oil when the engine
draining of oil.
a. Remove the
b. Remove the oil dip-stick (1).
c. Remove the oil drain plug (2)
gearbox (left side) and let the oil drain out. When
fully drained, reinstall the plug
(vari-
d. Fill up with new oil (1.5 liters) of
types:
- SAE 90 for ambient temperatures
between -6 and +32°C;
- SAE 140 for ambient temperatures
between
NOTE
element, and change the
the engine Operation and Maintenance
(running
gear/transmission oil (see fig. 21).
is
left wheel.
from
(2).
+32 and +60°C.
filter oil as
in)
hot to facilitate
the bottom of the
the following