Table of Contents
Advertisement
Available languages
Available languages
GB
Tilling width adjustment
The
adjustable tiller model allows you to set
widths of
40,
50,
60
cm,
Adjustment
of
tilling width
the position of the two pairs of outside
each tilling
element,
tiller rotor at the
end
Refer to figure
2
to
determine the
tion required to obtain
proceed as follows:
To reverse
the
position of
(fig. 3,
item
1),
remove the four attachment nuts
invert
the
position of the outside pair of tiller ro- tors,
fitting
the
left rotor to the
Make
sure you
keep
facing
the
front
of the machine.
to
suit the type of crop.
is obtained
by
reversing
tiller rotors
and by removing or adding one
of the two tillers.
tiller
rotor configura-
the
desired tilling
width,
the outside
tiller
rotor pairs
right
and
vice-versa.
the cutting
edge
of
the
Adjustment of protection guards
working
a.
Adjust width
width.
1),
and
of
b. Adjust width of matching piece
screws
Tilling depth adjustment
then
To vary tilling
tine
(fig. 5,
a. Remove nut and bolt (2).
(2)
and
b.
Move the
corresponds
rotors
Replace nut and
Ground adjustment
Adjust
the position of
sure correct movement over different types of
HARD GROUND
If
the tiller
tine to
lift
SOFT GROUND
If
the tiller tends to sink
to move the center of
ROTARY TILLER MAINTENANCE
After the first 50 hours (running in)
a. Check that all
necessary.
b.
Change the oil in the tiller
Remove plug
ment upside down to drain out the exhausted oil.
Return the
add 0.3 I of the same oil
of protection guards to suit new tilling
To do
this,
remove
the screws
install
the two
side extensions (2).
(4).
depth you must adjust the height of the
item
1).
Proceed
as follows:
tine
up
or down until
the
to the
desired hole on
bolt
(2)
and fully
the
rotary
tiller
tends to
jump
on
hard
the rotary
tiller.
in
on soft
ground,
gravity
over the machine
nuts
and bolts are secure.
drive unit
(fig.
6, item
1)
attachment to the upright position,
used
(fig.
4, item
(3)
by use of
slot on
the
bracket
the
tine
shank.
tighten.
as follows to en-
ground:
ground,
lower the
lower
the tine
wheels.
Tighten
if
as follows.
and
turn
the attach-
and
for the
gearbox.
Advertisement
Table of Contents
