Table of Contents
Advertisement
Available languages
Available languages
GB
COUPLING ATTACHMENTS TO
THE PTO
The PTO is fitted with an
attachments quickly and easily.
Proceed as follows to fit your attachments
19):
a. Check that lever (1) is in
b. Push the shaft of the attachment
(3). Make sure that it engages fully.
c. Lower lever
(1)
to the
that the
attachment is correctly locked.
WHEELS
TRACK ADJUSTMENT
Track width can be adjusted to suit the type of wheel
fitted.
Wheels (4.00-8) without adjustable rim
These
wheels, that are fitted
1)
by means of four studs
nuts, can be installed in a single position only, there-
fore,
track
cannot be modified.
Wheels (4.00-10) with adjustable rim
This
type of wheel is fastened to the hub (fig.
1) by means of four studs
and
is
provided with an adjustable
Track adjustment
is
(3)
either on the
inside
and securing
it
with the screws
quired to suit the chosen rim width.
Flange
(3)
can be positioned on the
with the protruding part pointing to either direction.
If the flange
is installed
protruding portion can point to the
instant
adaptor device to fit
"disengaged"
position.
(2)
into the PTO
"engaged"
position. Check
to
the hub
(fig.
(2)
and
the
associated
(2)
and
the
associated
rim.
carried out by placing the flange
or the outside of the rim
(5)
and nuts
NOTE
inside
on the outside of the rim, the
only.
outside
Three different adjustments of track are thus
(see
fig.
20/1,
item
20/2,
item
nuts,
(4),
(6)
as re-
of the rim
possible.
Advertisement
Table of Contents
