Flash 1107M Manual page 113

GB
Cutting height adjustment
Proceed as follows to adjust cutting height.
SICKLE BAR MOWERS WITH MIDDLE CUT FINGERS
AND ADJUSTABLE SHOES (fig. 4)
a. Loosen the screw (1)
b. Adjust the skids (2) as necessary to set the re-
quired cutting height.
c. Tighten again the screw (1) fastening each
SICKLE BAR MOWERS: E.S.M and MIDDLE CUT
FINGERS WITHOUT SHOES
a. Loosen the two nuts (1) and (2) that secure each
of the two support slides
b. Regulate the two
is at the desired height
c. Tighten the nuts
port slides
that fastens each skid (2).
(fig. 5)
support slides (3) until the blade
(1) and (2) again on the two sup-
SICKLE BAR MOWERS SPECIAL type (fig. 6)
a. Loosen the nut (1) that secures each of the two
support slides
b. Regulate the two support slides (2) until the blade
is at the desired height
a. Tighten the nut (1) again on the two support slides
skid.
Knife mechanism
bath movements)
At regular intervals check the play between the knife
and the roller.
If play becomes excessive, adjust as follows (see fig. 7):
a. Loosen bolts (1).
b. Turn adjuster screws (2) until play between roller
(3) and push-rod is as
c. Tighten bolts (1) again.
(2)
adjustment (rocker arm and
required.
oil