Flash 1107M Manual page 102

GB
CAUTION
Gear lever
When using the machine as
dlebars must be rotated through 180°.
The gear and PTO control levers therefore
change position. See page 17 for details.
Use the gear lever as shown below
a. Turn the throttle control
b. Pull up clutch lever.
c. Move the lever to the neutral position.
d. Set the speed preselection control lever (1)
versions 3+2) to the fully forward position (see the
placard shown in detail A).
e. Move the gear lever (2) to the required position
the plate illustrated in detail B1), and release it as
soon as the gear is engaged.
f. Gradually release the clutch
ing the engine.
g. To disengage gear, pull up the clutch lever and
move gear lever (2)
A safety device does not permit
engaged when the PTO
The Special version of the two-wheel tractor
is fitted with a preselection lever for
engagement of the 3rd speed (forward
speed only).
The levers are operated as follows
a. Turn the throttle control lever to idle position.
b. Pull up clutch lever.
c. Move the gear lever (2)
position "0" which is indicated by the
YELLOW marking.
d. Pull the 3rd speed preselection control
lever (1) to the fully aft position
placard shown in de-
e. Move the gear lever (2)
which is indi- cated by the YELLOW
marking (see the placard shown in
detail B2), and release the lever after en-
gagement is obtained.
f. Slowly release the clutch lever while
accelerating the engine.
g. To disengage the
clutch lever, and return the
position which
"O"
YELLOW marking.
C
a motor mower, the han-
(see fig. 6):
lever to idle position.
lever while accelerat-
to the neutral position.
WARNING
reverse speed to be
is operating (rotary tilling).
(see fig. 6):
to the neutral
(see the
tail A).
to position 3
3rd speed, pull the
lever (2) to
is in- dicated by the
3rd speed preselection control lever
(two-wheel
inter-
(only for
(see
To return the two-wheel tractor to the configuration of
version 2+2,
selection control lever
position.
Power Take Off
(two-wheel tractor configuration)
When using the machine as a motor mower, the han-
dlebars must be rotated through 180°.
The gear lever and PTO control lever therefore
change position. See page 17 for details.
The Power Take Off
drive to the rotary tiller.
To engage and disengage drive, proceed as follows
(see fig. 7):
a. Turn throttle control lever
b. Pull up clutch lever.
c. Pull PTO control lever (1) and release
is engaged
d. Release the clutch lever while accelerating the en-
gine.
The clutch lever must be released slowly to prevent
damage to the drive. Do not start working with at-
tractor version Special 3+2)
AUTION
it is necesssary to move the speed pre-
(1) back to
(PTO) control lever
CAUTION
(PTO) control lever engages the
to idle position.
(see plate in detail A and B).
CAUTION
the fully forward
inter-
it when drive