Surface Or Wall Mounting - StarTech.com NETRS2322P Manual

2-port serial-to-ip ethernet device server - rs232

Hide thumbs Also See for NETRS2322P:

Table of Contents

4. Press and hold the Factory reset button until the device server beeps twice.

5. Wait thirty seconds and disconnect any power sources from the device server and

reassemble the housing.

Note: The Reset button on the outside of the device server is a hardware reset that

reboots the device server. The Factory reset button is located on the PCB near the

LEDs.

Surface or wall mounting

• Use the device server's integrated mounting holes and screws (not provided) to

fasten and secure the device server to a wall or surface.

Instruction Manual

Table of Contents

Do you have a question about the NETRS2322P and is the answer not in the manual?