Charging - JVC GY-DS100U Detailed User Manual

Getting Started

Charging

This unit is equipped with a built-in battery.
Open the connector cover, and connect the cable as shown in the figure.
To DC/USB Device Terminal (Type-C)
AC Adapter (Provided)
.
Caution :
The built-in battery is not charged at the time of purchase.
0
At the time of purchase or in case of the battery is not used for a long period
0
of time, the charging time will be longer than usual.
Charging time: Approx. 5 h (when charging at 25°C (77°F))
0
The battery cannot be charged outside the room temperature range of
0
10°C to 35°C (50°F to 95°F). The CHARGE lamp blinks slowly as a
notification if charging does not start. If the temperature increases or
decreases during charging, the CHARGE lamp will blink slowly and
charging will stop. When this occurs, charge the camera again within the
above room temperature range.
Using the supplied AC adapter allows charging to be performed
0
concurrently during recording or playback. (Charging time may be longer
than usual or charging may not be successful in some cases.) If the internal
temperature rises when using the unit, stop the charging temporarily. (The
CHARGE lamp blinks slowly when this occurs.)
When the system is in the "Exchenge mode", charging cannot be
0
performed unless the power is turned off.
If malfunctions (such as overvoltage) occur, charging will stop. In these
0
cases, CHARGE lamp blinks quickly as a notification.
During charging, the P icon on the screen changes to O to indicate that
0
charging is in progress. (when the provided AC adapter is used)
When the recording time becomes extremely short even when the battery
0
is fully charged, the battery needs to be replaced. For details on replacing
the built-in battery (subject to a fee), consult the nearest JVC service
center.
6
CHARGE POWER/ACCES
CHARGE Lamp
Lights up: Charging in
progress
Goes out: Charging
finished
Blinking: See below
Connect Power
Cord to Outlet
(AC 100 V to 240 V)
Power Cord (Provided)
Using a Power Bank
Connecting to a power bank charges the built-in battery of this unit and
supplies the power during recording.
Usable power bank
0
– Output rating: 5 V, 3 A or higher
– Battery capacity: 10000 mAh or more (recommended)
– Power bank that comes with a USB Type-C terminal or a cable with a
USB Type-C plug on one end
* This unit is not guaranteed to operate with all power banks that meet the
above requirements.
Similar to the AC adapter, connect the cable of the power bank to the
DC/USB device terminal (Type-C).
Caution :
Refer to "Caution" under the "Charging" section. The charging time is
0
about the same as the AC adapter.
This camera may not be fully charged if the power bank used for charging
0
it has a small capacity.
Do not apply strong force to the DC/USB terminal when recording with the
0
power bank connected. In addition, take note that the Waterproof, Dust-
proof, Drop-proof and Freeze-proof functions do not function when the
terminal cover is opened.
Memo :
For details on using the power bank, refer to the instruction manual of the
0
power bank.
For questions on the power bank, please consult the dealer or
0
manufacturer of the power bank.