Additional Instructions - Raider PRO RDP-SGT20 User Manual

Hide thumbs

Table of Contents

1.5.3. If you run activities where there is a risk cutting tool may contact hidden wiring, hold the

tool only for the insulated gripping. Upon entering the tool in contact with live wires it metal parts

of the battery grass trimmer and this could lead to electric shock.

1.5.4. Use proper utensils to find any hidden beneath the surface pipelines, or contact the

local utility company. Entering into contact with live wires can cause fire and electric shock.

The damage to the pipeline could lead to an explosion. Penetrating a water line causes property

damage or may cause an electric shock.

1.5.5. Keep stable machine.

1.5.6. Clean vents of your cordless grass trimmer.

1.5.7. Use only recommended battery and charger.

1.5.8. The battery should always be kept away from heat sources. Do not leave it for a long time

in an environment with high temperature (of the sun places near heaters or where the temperature

exceeds 50 ° C).

1.5.9. Do not fully recharge the battery, otherwise it may be damaged.

1.5.10. Avoid charging the battery at temperatures below 0 ° C.

1.5.11. The charger is designed to work with her. It should not be used for other purposes.

1.5.12. Do not place, any metal objects into the charger.

1.5.13. The battery must be recharged when it fails to produce enough power to operate. Do

not continue to use the trimmer in these conditions. Follow the loading procedure. You can also

charge the battery partially used when you wish, without adverse effect on battery ..

1.5.14. To clean the battery grass trimmer, use a soft, dry cloth. Never use any solvent or

alcohol.

1.5.15. Before cleaning the charger, disconnect it from the network.

1.5.16. If you are charging the batteries one after another between charges make breaks of 30

minutes.

1.6. Special safety conditions at work with the charger.

Before proceeding to work with the charger must read all related to him and contained in this

instruction information and indications on the charger and battery, for which it is intended.

1.6.1. To reduce the risk of injuries and injuries charger should only be used to charge the

batteries of nickel-cadmium type. The batteries of another type may explode, causing serious

injuries or property damage.

1.6.2. The charger should not be exposed to the influence of moisture or water.

1.6.3. The use of attachment not recommended or sold items from the charger manufacturer

jeopardized by fire, causing injury or electric shock.

1.6.4. The power cord should not be walked on. It should not be located in the passage where

people pass and should not be subjected to any other danger (eg too much tension).

1.6.5. If not necessary, do not use extension cord. Using an improper extension cord may

cause fire or electric shock. If using an extension cord is necessary, first make sure whether the

contact of the extension corresponds to the pins on the original connector, power charger.

1.6.6. The extension must be in good working order.

1.6.7. Not for use charger with a damaged cord or plug. The damage must be repaired by a

qualified person.

1.6.8. Not allowed to use the charger if it has been subjected to a strong impact, fall or has been

damaged otherwise. Inspection and possible repair should be entrusted to an authorized service

RAIDER.

1.6.9. Do not allow attempts to disassemble the charger. All repairs must be entrusted to

authorized service RAIDER. Improper installation of the charger threatening electric shock or fire.

1.6.10. Before conducting any scheduled maintenance or cleaning the charger, it should be

unplugged.

1.6.11. The charger can be excluded from the mains when not in use!