Controller Abnormality Voice Alarm - On/Off Setting; Clear Historical Data And Reset To Factory Settings; Load Modes - Go Power MPPT-PRO User Manual

9.7.3 CONTROLLER ABNORMALITY VOICE ALARM - ON/OFF SETTING

BUZZER STATE
No Alarm
Alarming: 1 min
Alarming: 15 sec
Alarming: Persistent
CHARACTER DISPLAYED
Voice alarm: ON
Voice alarm: OFF
Enter into the setting manual, tap
and again use , to switch between ON and OFF. Tap
modification.
Factory settings disable the voice alarm function by default (the aforementioned faults will not trigger alarms with the voice
alarm disabled.

9.7.4 CLEAR HISTORICAL DATA AND RESET TO FACTORY SETTINGS

ClrHistoryData YES, clear historical data
RestoreDefault  YES, reset to factory settings
Tap to enter into the submenu, and a NO and YES selection menu will pop up. Use
again, and YES will flash a few times. If NO is selected, tap

9.8 LOAD MODES

• If the characters displayed on top of <Mode> are ON, it indicates that the load is switched on, and OFF indicates the
load is switched off.
• Tap to enter into the load setting mode, and right below the <Mode>, the mode characters or digits will begin to
flash. Use , to select any one from the load modes listed in the following table, and tap
the load mode setting.
• Press and hold in any menu but not the setting mode: if the current load mode is "manual mode", pressing and
holding the key will switch on/ off the load; if the current load mode is not "manual mode", pressing and holding the key
will cause the display to skip to the load mode setting interface and a reminder will pop up telling the user in this mode,
pressing and holding the key will not switch on/ off the load. For parameters on the current menu, those highlighted
ALARM TYPE
System running well
Battery over-discharge, Load short circuit/overload, controller
or battery over-temperature
Battery under-voltage
Battery over-voltage,solar panel reverse connection,solar panel
over voltage
DESCRIPTION
Voice alarm enabled
Voice alarm enabled
, to move to Voice Alarm: XXX, tap
Load mode setting icon
to enter into the parameter setting mode,
to confirm the modification, or tap
to directly return to the previous level.
Load state
Load mode
REMOTE
to cancel the
, to select YES, then tap
again to complete
gpelectric.com | [page 33]