Configuring Remote Control Of Dhi-Ipmecd-302X Barrier Gate; Checking System Functions - Dahua ITC413-PW4D Series Installation And Configuration Manual

4.2.2 Configuring Remote Control of DHI-IPMECD-302X Barrier Gate

● Match the remote information
Successful matching: Press and hold the learning button on the receiver for 2 s, press the remote
◇
handle at least twice and then you can press keys on the remote to control the arm.
Failed matching: The remote handle is not pressed a while after pressing the learning button on
◇
the receiver, and the receiver indicator does not flash 3 times immediately, but flashes 7 times
after about 8 seconds.
Clear the remote information: Press and hold the learning button on the receiver for more than 3

seconds, and then the remote cannot control the arm. This means the matching information has
been cleared.

Checking System Functions

Item Functions
Capture
Camera
Barrier
control
Receiver
Contents
After the vehicle passes through the capture line, check
whether there are snapshots and recognition results
generated on the webpage. If there are, it means that the
capture function is normal.
opening Check the physical circuit of the camera and the barrier
opening parameters for camera allowlist.
35
Installation and Configuration Manual