JRC INMARSAT FleetBroadband FB250 Operation Manual page 34

Maritime satellite communication terminal
Hide thumbs Also See for INMARSAT FleetBroadband FB250:
Table of Contents

Advertisement

3. Appearance
3 SIM card slot
Mounts a SIM card.
4 Earth
5 WRF connector
Connects with Wide-band Radio Frequency (WRF) communication equipment such as Chartco etc.
6 Antenna cable connector
Connects with the coaxial cable from the antenna (ADE).
7 Fuse
Melt down when over current are detected.
Replacement procedure:
screwdriver, and pull out the folder when it is ejected. Replace the fuse to new one and set it in the
folder. Insert the folder and tighten it clockwise direction until folder is securely locked in place.
8 DC power connector
Connects with the cable which supplies the power source to the main unit.
9
Audio port (RJ-45 type 8-PIN Modular Cable for ISDN)
Connects with equipment, which has an ISDN interface.
Offered services: 4kbps Voice
10 Ethernet port (RJ-45 type 8-PIN Modular Cable for Ethernet)
Connects with an equipment which has an Ethernet interface.
Offered services: Standard IP, Streaming IP, and SMS.
11 USB port (USB Cable series B plug)
Connects with an equipment which has a USB interface.
Offered services: Standard IP, Streaming IP, and SMS.
USB cable PC side :series A (male)
Main unit side:series B (male)
* The connection using USB hub is not supported yet.
12 Handset port (12-PIN Modular Cable)
Connects with Handset unit.
Offered service: 4kbps Voice and SMS
13 TEL 1/2 ports (RJ-11 type 6-PIN Modular Cable)
Connects the analog equipment, terminal telephones, and facsimile to the main unit.
Offered services: 4kbps Voice and 64kbps 3.1kHz Audio
Loosen the folder head to counterclockwise direction with slotted
16

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jue-250

Table of Contents