Table of Contents
Advertisement
A.3 Screen display of Handset (Corresponded to Chapter 4.1)
ON
Initializing
Initialize
Initial Heading value requesting
Heading ？
Satellite searching
APAC E143.5
14:03 UTC
SAT SEARCH
Registering to network
APAC E143.5
14:03 UTC
REGISTERING
Communication available status
APAC E143.5
14:03 UTC
CS PS READY
[READY]
lamp lit.
Appendix A Changing procedures of using GYRO tracking
Turn on JUE-250 by pushing power switch
of Main unit.
A LED of Main unit starts blinking.
About 10 seconds later, initializing is started
and blinking [Initialize] text is displayed.
Input Heading value when it is required.
Note) this screen appears when:
• GYRO type is SYNC/STEP, and an
initial Heading value is not set yet.
• GYRO type is NMEA, and JUE-250
cannot obtain Heading information from
GYRO.
[SAT SEARCH] text is displayed in the
lowest, [Status] line.
started.
Satellite search is terminated and then
[REGISTERING] text is displayed.
Registering to Inmarsat network is started.
Registering is terminated and [CS PS
READY] text is displayed.
Various services are available. (About the
operation after this screen, refer to chapter
4.1.4 or later).
Fig.A.3 Screen display of Handset
(when GYRO is used)
137
Changed
Satellite search is
Advertisement
Table of Contents
