Adjust The Offset Of Lock Mechanism - Steel And Plastic Heads - Hunter TCX50H Series Operation Manual

Adjust the Offset of Lock Mechanism – Steel and Plastic Heads
1- Again, position the mount/demount head on the outer edge of upper rip lip and lock in this
position.
2- Use gauges to measure distances between head and the top of the rim. Measure at
inserts on steel head.
Change the offset by removing the plastic cover and adjusting the nuts located on front of the
locking mechanism.
Replace the plastic cover.
Confirm head clearances to the 17 in rim are correct. Position the mount/demount head on the
outer edge and lock in this position. Check clearances.
36
TIRE MOUNTING LIP
TOP GAP
Measure with feeler gauge
5/64-inch specification
TIRE DEMOUNTING LIP
SIDE GAP
Measure with feeler gauge
5/64-inch specification
Operation Instructions for TCX50H Tire Charger