Special Procedure - Hunter TCX50H Series Operation Manual

An exploding tire and rim may be propelled upward and outward with enough force
to cause serious injury or death.
Do not mount any tire unless the tire size (molded into the sidewall) matches the rim
size (stamped into the rim) exactly or if the rim or tire are defective or damaged.
This tire changer is not a safety device and will not restrain exploding tires and rims.
Keep area clear of bystanders.

Special procedure

In case during inflation the tire does not seat on the rim because of the excessive gap
between tire/rim, it is possible to use a air-pressure airblast through jaws on turn table.
Verify that both upper and lower tire beads and rim bead seat have been properly lubricated
with an approved mounting paste.
Remove valve stem core if not already done.
Connect inflation hose to valve stem.
Pull up on the tire lightly to reduce the gap between upper bead and the rim.
Do not stand over tire during inflation.
Step down completely on the air inflation pedal (pedal on the left side of the base) to release a
high-pressure air blast through jets on the clamps to assist in seating the beads of the tire.
28
WARNING
WARNING
Operation Instructions for TCX50H Tire Charger