Tire Bead Breaker Shovel Control; Wheel Clamping Pedal - Hunter TCX50H Series Operation Manual

1.11 Tire Bead Breaker Shovel control

Keep arms and legs from between the bead breaker arm and the side of the housing.
Press the "In" button to close bead breaker arm and loosen bead
Press the "Out" button to allow the bead breaker arm to open (black arrow).

1.12 Wheel Clamping Pedal

Internal Clamping:
Press the pedal all the way down to close the 4 sliding clamps completely.
Put the wheel on the table top and depress pedal all the way down, (the pedal will move in the
upper position). The 4 sliding clamps will open and clamp the wheel.
External clamping:
Press the pedal to the middle position to position the 4 sliding clamps so that the reference on
the table top is more or less in line with the tire diameter stamped on the sliding clamp.
Place the wheel on the table top and push down on the wheel while depressing the pedal all
the way to clamp the wheel.
18
WARNING
CRUSH HAZARD
The wheel clamping pedal has three positions (modes of operation): up
(expand), neutral (stop), and down (retract).
With the clamps in the fully retracted position or clamped against the
outside of a rim, step down fully on the pedal to expand the wheel clamps
(clamps move outward). The clamps continue to expand until contacting
the rim or until fully expanded.
CRUSH HAZARD
(red arrow).
Operation Instructions for TCX50H Tire Charger
EXPLOSION HAZARD
4-402023