Table of Contents
Advertisement
2. General Information
2.1 Performances
Values are as measured per test method, except for the recommended heating area, firebox volume,
maximum burn time and maximum heat output.
Model
Fuel Type
Recommended heating area (sq. ft.
Nominal firebox volume
Maximum burn time
1
Maximum heat output (dry cordwood)
Overall heat output rate (min. to max.)
Average overall efficiency
Dry cordwood
Optimum efficiency
6
Average particulate emissions rate
Average CO
9
Recommended heating area and maximum burn time may vary subject to location in home, chimney draft, heat loss factors, climate, fuel type, feed
1
rate, fuel level, and other variables. The recommended heated area for a given appliance is defined by the manufacturer as its capacity to maintain a
minimum acceptable temperature considering that the space configuration and the presence of heat distribution systems have a significant impact
in making heat circulation optimum.
The maximum heat output (dry cordwood) is based on a loading density varying between 15 lb/ft
2
a fuel load prescribed by the standard. The specified loading density varies between 7 lb/ft³ and 12 lb/ft
and 25%.
As measured per CSA B415.1-10 stack loss method.
3
Higher Heating Value of the fuel.
4
Lower Heating Value of the fuel.
5
Optimum overall efficiency at a specific burn rate (LHV).
6
This appliance is officially tested and certified by an independent agency.
7
Tested and certified in compliance with CFR 40 part 60, subpart AAA, section 60.534(a)(1(ii) and Draft ASTM WK47329-14.
8
Carbon monoxide.
9
Page 8
Solution 2.3 (EB00041)
Dry Cordwood
)
500 to 2,100 ft
.
1
2.4 ft
8 hours
75,000 BTU/h (22.0 kW)
2
14,800 BTU/h to 28,600 BTU/h
2 3
(4.34 kW to 8.38 kW)
3
69 % (HHV)
77 %
1.54 g/h (EPA / CSA B415.1-10)
7
89.4 g/h
(47 to 195 m
2
(0.068 m
)
3
3
74 % (LHV)
4
and 20 lb/ft
3
. The moisture content is between 19%
3
Installation and Operation Manual - Solution 2.3
)
2
5
8
. Other performances are based on
3
Advertisement
Table of Contents
