Table of Contents
Advertisement
5.6
Air Intake Control
Once the firewood, firebox and chimney are hot, air intake can be reduced to achieve a steady
burn.
As the air intake is reduced, the burn rate
decreases. This has the effect of distributing
the thermal energy of the fuel over a longer
period of time. In addition, the flow rate of
exhaust through the appliance and flue pipe
slows down, which increases the duration of
the energy transfer of the exhaust gases. As
the air intake is reduced, the flame slows down.
If
the
flames
diminish
disappearing, the air intake has been reduced
too early in the combustion cycle or the wood
used is too wet. If the wood is dry and the air
control is used properly, the flames should
decrease, but remain bright and stable.
On the other hand, too much air can make the fire uncontrollable, creating very high temperatures
in the unit as well as in the chimney and seriously damaging them. A reddish glow on the unit
and on the chimney components indicates overheating. Excessive temperatures can cause a
chimney fire.
5.7
Fire Types
Using the air intake control is not the only way to match the fireplace heat output to the desired
temperature in the house. A house will need far less heating in October than in January to
maintain a comfortable temperature. Filling the firebox full in fall weather will overheat the space.
Otherwise, the combustion rate will have to be reduced to a minimum and the fire will be smoky
and inefficient.
Here are some suggestions for building fires suitable for different heating needs.
5.7.1
Flash Fire
To build a small fire that will produce a low heat output, use small pieces of firewood and load
them crisscross in the firebox. The pieces should only be 3» (76 mm) to 4» (102 mm) in diameter.
After raking the coals, lay two pieces parallel to each other diagonally in the firebox and lay two
more across them in the other direction. Open the air control fully and only reduce the air after
the wood is fully flaming.
This kind of fire is good for mild weather and should provide enough heat for up to four hours.
Small fires like this are a good time to use softer wood species and avoid overheating the house.
5.7.2
Low and Long Output Fires
For a fire that will last up to eight hours but will not produce intense heat, use soft wood and
place the logs compactly in the firebox. Before reducing the air intake, the load will have to burn
at full heat for long enough for charring the surface of the logs. The flame must be bright before
letting the fire burn by itself.
Installation and Operation Manual - Solution 2.5ZC II
to
the
point
of
Page 23
Advertisement
Table of Contents
