ABB C310 Programming Manual page 39

...4 CONFIGURATION
...4.10 Set Up Control Page
LOGIC3
NONE
LOGIC4
NONE
C–OUt
LASt
F–SP–I
800
F–SP–2
200
SEtUP
ALArMS
36
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Logic Input Type 3 (not available on COMMANDER 310)
Refer to Section 4, Figs. 4.18 and 4.19 in the Installation
Guide
.
Select the logic input type for input 3 (must not be the same
as any other logic input type). The selections and their
actions are as for
Logic Input 1
frame for details.
Logic Input Type 4 (not available on COMMANDER 310)
Refer to Section 4, Figs. 4.18 and 4.19 in the Installation
Guide
.
Select the logic input type for input 4 (must not be the same
as any other logic input type). The selections and their
actions are as for
Logic Input 1
frame for details.
Configured Output
Select the configured output, between 0.0 and 100.0% in
0.1% increments, or
If is selected for any of the logic inputs above, the
AUtMAN
manual control output equals the
unless the configured output is
LASt – last auto output, i.e. the manual output
tracks the automatic output. Found
below 0%.
Fixed Dual Set Point 1
If the selection in any of the four logic inputs is
fixed set point may be set. Set the fixed set point required.
Fixed Dual Set Point 2
If the selection in any of the four logic inputs is
fixed set point may be set. Set the fixed set point value
required.
Return to the top of
Set Up Control Page
next programming page.
– refer to
– refer to
.
LASt
Configured Output
.
LASt
or advance to the
Logic Input 1
Logic Input 1
,
a
F–SPt
a
F–SPt