ABB C310 Programming Manual page 38

...4.10 Set Up Control Page
LOGIC1
AUt MAN
LOCrE M
P-Strt
P-rSEt
LOGIC2
AUt MAN
LOCrE M
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Option
board
OPtION
error
NONE
ACK
F-SPt
P-SKIP
NONE
ACK
Option Board Disable (not applicable on
COMMANDER 310)
ON
If the Option board fails or is removed, press
to set
this parameter is omitted.
Logic Input Type 1
Refer to Section 4, Figs 4.18 and 4.19 in the Installation
Guide
.
Select the logic input type for input 1 (must not be the same
as any other logic input type):
– no function available
NONE
– auto/manual
AUtMAN
– local/remote (dual)
LOCrE M
– remote alarm acknowledge
ACK
– fixed dual set point
F-SPt
P-Strt – program start/hold function
P-rSEt – program reset function
P-SKIP – segment skip function
If is set then the output reverts to the value set in
AUtMAN
below, unless configured output is set to
Configured Output
.
LASt
If is selected two fixed set points are available –
F–SPt
see
Fixed Dual Set Point 1
If is selected, the adjustable dual set point facility
F–SPt
is disabled and the dual set point is the value of one of the
two fixed set points.
Dual set point must be selected (in
Section 4.2) in order to enable the use of the fixed set
points.
If is selected at
dUAL
the Local/Remote selection becomes Local/
Points Page
Dual selection.
Logic Input Type 2
Refer to Section 4, Figs. 4.18 and 4.19 in the Installation
Guide
.
Select the logic input type for input 2 (must not be the same
as any other logic input type). The selections and their
actions are as for
Logic Input 1
frame for details.
1
Continued on next page.
4 CONFIGURATION...
to . Once set to
OPtION OFF
and
Fixed Dual Set Point 2
Set Points Page
Set Point Type Selection
above – refer to
OFF
below.
–
frame in
Set
Logic Input
35