Table of Contents
Advertisement
...4.6 Set Up Remote Set Point Input Page
LIN–LO
r–HI–2
rtd
or
tc–x
dEC–Pt
r–LO–2
bSPd– 2
FdLP–2
dEFACt
dF–SP
NONE
dF-SPt
or
LOCAL
dEF–SPt
dISPLY
PAGE
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
0
20.0
20.0
4.0
NONE
UP
dN
10.0
NONE
LOCAL
t
500.0
SEtUP
o r
PSN–Fb
Linearizer Zero
Set the range minimum temperature in °C or °F as selected
at
above, within the limits detailed in Table
Linearizer Units
4.1.
Remote Set Point Range Full Scale
Set the remote set point range full scale value within the
limits in
– see page 18.
Table 4.2
Decimal Point
Set the decimal point position required for
full scale and range zero values.
Input Range Zero
Set the remote set point range zero value required within
the limits in
Table 4.2
Broken Sensor Protection Drive
In the event of a fault being detected on the input, the
remote set point is driven according to the Broken Sensor
Protection Drive. Select the drive required:
drive,
for upscale drive or
UP
Fault Detection Level Percentage, Remote Set Point
This frame is as detailed in the
Percentage, Process Variable Input
Set the value required, between 0.0 and 100.0% in 0.1%
increments.
Default Action (Remote Set Point)
Select the default action required in the event of an error:
–
No default action.
NONE
–
The controller reverts to local mode
LOCAL
when an error is detected and the local
set point value is used.
–
The controller reverts to local mode
dF–SPt
when an error is detected and the set
point value changes to the
Point
Default Set Point
Set the default set point value required in the event of an
error.
Return to top of
Remote Set Point Input Page
the next programming page.
4 CONFIGURATION...
– see page 18.
for downscale drive.
dN
Fault Detection Level
frame – see page 19.
value below.
the range
both
for no
NONE
Default Set
or advance to
21
Advertisement
Table of Contents
