Table of Contents
Advertisement
OS Series Handheld DSO & DMM
10.1 Appendix A: Specifications
10.1.1 Oscilloscope
Only if other instructions are provided, are all technical specifications applicable to the probe with
the 10X attenuation switch setting and the OS series digital type oscilloscope. In order to be up to
these specifications, the oscilloscope should meet the following requirement.
■
The instrument should operate continuously for more than 30 minutes under the specified
operating temperature.
■
If the operating temperature is up to or larger than 5 Celsius degrees, the system function
menu must be opened to make the system perform a "Auto- calibration" procedure (see
"calibration" on P55).
Except those specifications marked with the word Typical, all specifications can be up to.
Sampling
Sampling modes
Sampling rate
Input
Input coupling
Input impedance
Probe attenuation coefficient
Max. Input voltage
Channel delay time（typical）
Horizontal
Sampling rate range
Waveform interpolation
10. Appendix
Normal sampling
Peak detection
Average value
100 MSa/s----OS-1022
Max 500 MSa/s----OS-2062
Max 1 GSa/s----OS-3102
DC, AC, Ground
● 1MΩ ± 2% connected in parallel with 20pF ±
5pF----OS-1022
● 1MΩ ± 2% connected in parallel with 15pF ±
5pF----OS-2062, OS-3102
1X, 10X, 100X, 1000X
400V (peak)
150ps
0.25S/s～100MS/s----OS-1022
0.25S/s～250MS/s----OS-2062
0.25S/s～1 GS/s----OS-3102
（sin x）/x
77
10-Appendix
Advertisement
Table of Contents
