OS Series Handheld DSO & DMM
the screen turns into one blue in color and shows the peak-to-peak value of CH2.
Now, you can see a screen that looks like the following figure 51.
8.11 Setting the Cursor Measurements
This oscilloscope allows you to make manual cursor measurements on time and voltage. The
signal sources include Channel 1(CH1), Channel 2 (CH2).
8.11.1 Setting the cursor measurement in normal mode
The cursor measurement menus are listed and described in the following table.
Function menus
Type
Source
Delta
Cur1
Cur2
To make a voltage measurement on CH1, doing the following:
Figure 51: Automatic Measurements
Settings
Description
OFF
Close the cursor measurement.
Voltage
Display the voltage measurement cursor and menu.
Time
Display the time measurement cursor and menu.
Select the waveform channel on which the cursor
CH1, CH2.
measurement will be performed.
Display the difference of measured value
between the two channels
Display the relating measured value of
Cursor 1
Display the relating measured value of
Cursor 2
57
8-Advanced Function of Oscilloscope