Table of Contents
Advertisement
+
System 300S
Proceeding transfer via
PROFIBUS interface
5.10.2
Transfer via Ethernet
Initialization
Transfer
HB140 | CPU | 315-4PN23 | en | 18-02
5.
Set in the register MPI the transfer parameters of your MPI net and type a valid
address.
6.
Switch to the register Local connection.
7.
Set the COM port of the PC and the transfer rate 38400baud for the MPI program-
ming cable.
8.
Transfer your project via 'PLC è Load to module' via MPI to the CPU and save it
with 'PLC è Copy RAM to ROM' on a memory card if one is plugged.
1.
Connect your PC to the PROFIBUS jack of your CPU via a MPI programming cable.
2.
Load your project in the Siemens SIMATIC Manager.
3.
Choose in the menu 'Options è Set PG/PC interface'.
4.
Select in the according list the "PC Adapter (PROFIBUS)"; if appropriate you have
to add it first, then click at [Properties].
5.
Set in the register PROFIBUS the transfer parameters of your PROFIBUS net and
enter a valid PROFIBUS address. The PROFIBUS address must be assigned to the
DP master by a project before.
6.
Switch to the register Local connection.
7.
Set the COM port of the PC and the transfer rate 38400baud for the MPI program-
ming cable.
8.
Transfer your project via 'PLC è Load to module' via PROFIBUS to the CPU and
save it with 'PLC è Copy RAM to ROM' on a memory card if one is plugged.
Transfer via PROFIBUS is available by DP master, if projected as master
and assigned with a PROFIBUS address before.
Within selecting the slave mode you have additionally to select the option
"Test, commissioning, routing".
For transfer via Ethernet the CPU has the following interface:
n
X5: Ethernet PG/OP channel
n
X8: PROFINET IO Controller
So that you may access the Ethernet PG/OP channel you have to assign IP address
parameters by means of the "initialization".
Ethernet PG/OP channel' page 42
1.
For the transfer, connect, if not already done, the appropriate Ethernet port to your
Ethernet.
2.
Open your project with the Siemens SIMATIC Manager.
Set via 'Options è Set PG/PC Interface' the access path to "TCP/IP ® Network
3.
card .... ".
Deployment CPU 315-4PN23
Project transfer > Transfer via Ethernet
Ä Chap. 5.6 'Hardware configuration -
53
Advertisement
Table of Contents
