Table of Contents
Advertisement
Section 3 - Configuration
Go to Features > Static Routes, then click IPv6 to configure the IPv6 Static Routes.
To configure the Static Route IPv4 settings, click the IPv4 tab. Refer to Static Routes - IPv4 on page 72.
Click Save at any time to save the changes you have made on this page.
If you wish to remove a rule, click
in the Edit column. If you wish to create a new rule, click the Add Rule button.
If you click on Edit or Add Route, the following options will appear:
Name
Enter a name for the route.
DestNetwork
Enter the destination network address of the route.
PrefixLen
Enter the number of prefix bits of the IP address that will take
this route. Enter a value between 64 and 128.
Gateway
Enter the IP address of the next hop, which is the gateway to
the remote network.
Metric
Enter a route metric value between 1 between 128. This value
indicates the cost of using this route.
Interface
Select the interface that the IP packet will use to transit out of
the router when this route is used.
D-Link G403 User Manual
Static Routes - IPv6
in the Delete column. If you wish to edit a rule, click
73
Advertisement
Table of Contents
