Table of Contents
Advertisement
Section 3 - Configuration
Status
Enable or disable the DHCP server.
DHCP IP Address
Enter the start and end IP addresses for the DHCP server's IP
Range
assignment. Note: If you statically assign IP addresses to your
computers or devices, make sure the IP addresses are outside of
this range or you may have an IP conflict.
DHCP Lease Time
Enter the length of time for the IP address lease in minutes.
The default is 10080 minutes.
Always Broadcast
Enable this feature to broadcast your network's DHCP server
to LAN/WLAN clients.
WAN Port Speed
You may set the link speed of the Internet port to 10 Mbps,
100 Mbps, 1000 Mbps, or Auto (recommended).
UPnP
Enable or disable Universal Plug and Play (UPnP). UPnP
provides compatibility with networking equipment, software,
and peripherals. This is enabled by default.
IPv4 Multicast Streams
Allow or disallow IPv4 multicast traffic to pass through the
router from the Internet. This is enabled by default.
IPv6 Multicast Streams
Allow or disallow IPv6 multicast traffic to pass through the
router from the Internet. This is enabled by default.
D-Link G403 User Manual
DHCP Server
Advanced Settings...
52
Advertisement
Table of Contents
