Table of Contents
Advertisement
Section 3 - Configuration
If you click Edit or Add Rule, the following options will appear:
Name
Enter a name for the rule.
Source IP Address
Enter the source IP address range (e.g. 1.1.1.1-1.1.1.2 for IPv4
Range
or 2001::1-2001::2 for IPv6) that the rule will apply to. Using
the drop-down menu, specify whether it is a WAN or LAN IP
address. Both a single IP address and a range of IP addresses
can be entered.
Destination IP Address
Enter the destination IP address range (e.g. 1.1.1.1-1.1.1.2
Range
for IPv4 or 2001::1-2001::2 for IPv6) that the rule will apply
to. Using the drop-down menu, specify whether it is a WAN
or LAN IP address. Both a single IP address and a range of IP
addresses can be entered.
Protocol & Port Range
Select the protocol of the traffic to allow or deny (Any, TCP, or
UDP) and then enter the range of ports (e.g. 21-23) that the
rule will apply to.
regardless of the port number.
Schedule
Use the drop-down menu to select the time schedule during
which the rule will be active. The schedule may be set to
Always Enable, or you can create your own schedules in the
Schedules section. Refer to Management > Time & Schedule
- Schedule on page 77 for more information.
A maximum of 24 rules can be defined.
D-Link G403 User Manual
Select Any to allow/deny all types of traffic
67
Advertisement
Table of Contents
