Toshiba TOSVERT VF-AS3 Manual page 30

(*1): VF-S15: When 14(sr0) is set to fmod, preset speed operation frequency 0 is selected.
Acceleration time 1 (acc) and deceleration time 1 (dec) are worked when cmod isn't "Communica
(*2):
tion option". If cmod is "Communication option", Acceleration and deceleration time 1 are worked by c
860, c862, c863, c865. See "7.1.
In this case, set 0(Linear) to acceleration/deceleration 1 pattern (f502: 0x2502). (S-pattern i
sn't supported.) If S-pattern is needed, use acceleration/deceleration 2 or 3.
VF-AS3
bit Function
0 Preset speed switching 1
1 Preset speed switching 2
2 Preset speed switching 3
3 Preset speed switching 4
4 V/f switching 1 (*2)
5 PID control OFF
6 Acc/Dec switching 1 (*3)
7 DC braking
8 Jog run
9 Forward/Reverse
10 Run/Stop
11 Coast stop
12 Emergency off
13 Fault reset
14 Frequency priority
15 Command priority
(*1): When set "12(sr0)" to fmod, preset speed operation frequency 0 is selected.
(*2): The V/f switching ORs with Bit 10 of fa23.
(*3): The Acc/Dec switching ORs with Bit 8 of fa23.
Acceleration time 1 (acc) and deceleration time 1 (dec) are worked when cmod isn't "Communica
(*4):
tion option". If cmod is "Communication option", Acceleration and deceleration time 1 are worked by c
860, c862, c863, c865. See "7.1.
In this case, set 0(Linear) to acceleration/deceleration 1 pattern (f502: 0x2502). (S-pattern i
sn't supported.) If S-pattern is needed, use acceleration/deceleration 2 or 3 or 4.
TOSHIBA Drive profile
0
0000: Preset speed operation OFF
(*1)
0001-1111: Setting of preset speed
operation frequencies (1-15)
V/f 1
PID control PID control
permitted prohibited
AD mode 1 AD mode 2
Forced DC
OFF
braking
OFF Jog run
Forward run Reverse run
Stop
Standby Cost stop
OFF Emergency off
OFF
OFF Enabled
OFF Enabled
TOSHIBA Drive profile
- 29 -
" for the detailed information.
1
Preset speed operation is disabled
or preset speed operation
frequencies (1-15) are set by
specifying bits for preset speed
operation frequencies 1-4.
V/f 1: pt = setting value, vl, vlv,
vb, thra
V/f 2
V/f 2: pt = "0", f170, f171,
f172, f182
-
AD mode 1: acc, dec (*4)
AD mode 2: f500, f501
-
-
-
Run -
-
Always enable, [E] trip
Reset Trip reset
Enabled regardless of the setting of
fmod
Enabled regardless of the setting of
cmod
" for the detailed information.
E6581818⑭
Note