Mma Welding; Softstart / Hotstart Function - Fronius TransPocket 150 TIG Operating Instructions Manual

5

MMA welding

1
2
3
SoftStart / Hot- This function is used to set the starting current.
Start function
Setting range: 1 - 200 %
Operating principle:
At the start of the welding process, the welding current is reduced (SoftStart) or
increased (HotStart) for 0.5 seconds, depending on the setting.
The change is shown as a percentage from the set welding current.
The duration of the starting current can be changed in the Setup menu using the
starting current duration (Hti) parameter.
Setting the starting current:
1
28
Use the welding process button to select one of the following
processes:
- MMA welding - the MMA welding indicator lights up after
selection
- MMA welding with Cel electrode - the MMA welding with
Cel electrode indicator lights up after selection
Press the setting value button until
- the welding current indicator lights up
Adjust the welding current using the adjusting dial
- power source is ready for welding
Press the setting value button until
-
the SoftStart / HotStart indicator lights up