Advertisement
Available languages
Available languages
metal part of the frame or engine block. g) When disconnecting charger, turn switches to off, disconnect AC
cord, remove clip from vehicle chassis, and then remove clip from battery terminal. h) See operating
instructions for length of charge information.
FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE OF THE VEHICLE OR HAS
9.
BEEN REMOVED FROM THE VEHICLE. A SPARK NEAR THE BATTERY MAY CAUSE
BATTERY EXPLOSION. TO REDUCE RISK OF A SPARK NEAR BATTERY:
a) Check polarity of battery posts. The POSITIVE (POS, P, + ) and NEGATIVE (NEG,N, - ) battery posts will be
clearly marked. b) Connect the POSITIVE (RED) charger clip to POSITIVE (POS, P, +) post of battery. c) Then
connect the NEGATIVE (BLACK) charger clip to the NEGATIVE (NEG, N, -) post of the battery. d) When
disconnecting charger, always do so in reverse sequence of connecting procedure & break first connection
while as far away from battery as practical.
10. SAFE USE BY MINORS OR PERSONS WITH REDUCED CAPABILITIES: a) This appliance can be used by
children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or
lack of experience and knowledge only if they have been given supervision or instruction concerning use of
the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
b) Choking Hazard. Accessories may present a choking hazard to children. Do not leave children unattended
with product or any accessory. The product is not a toy.
11. RADIO FREQUENCY INTERFERENCE: The OptiMate DUO complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference that may cause undesired
operation. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
12. PROPOSITION 65, STATE OF CALIFORNIA: Battery posts / terminals, and related accessories may contain
chemicals, including lead or sulphuric acid. These materials are known to the State of California to cause
cancer and birth defects and other reproductive harm
Three interchangeable connection sets are supplied with the battery charger (illustrations on pages 3 & 4).
1) A battery lead (O-01) with metal eyelet lugs for permanent fitment to the battery posts, with re-sealable
weatherproof cap on the SAE connector that connects to the charger output cable. Consult a professional
service agent for assistance in attaching the metal eyelets to the battery posts. Secure the connector with
weatherproof cap so that it cannot foul any moving part of the vehicle or the cable can be pinched or
damaged by sharp edges.
IMPORTANT: This battery lead is protected by a 15A fuse. If under any circumstance the fuse blows, do not
try and replace the fuse without first identifying and correcting the issue that caused the fuse to blow. Only
replace the fuse with a 15A rated ATO fuse.
2) A SAE to DIN plug adapter (O-19), to charge through a DIN /ISO 4165 12V power socket:
i) The auxiliary DIN socket on BMW motorcycles (Models: from 2004) can receive charge and maintenance
even with ignition turned off, when using a CAN-bus charge mode on OptiMate4 Quad program.
ii) Other vehicles fitted with a DIN socket: if the 12V DIN socket remains continuously powered up after the
ignition has been turned off, charge & maintenance can be delivered via the socket.
Find more DIN/ISO 4165 accessories at www.optimate1.com.
3) A set of battery clips (O-04), recommended for charging the battery off-vehicle or when the battery needs
a recovery charge. Read Section A > IMPORTANT SAFETY INSTRUCTIONS points 8 or 9 before connecting to
the battery.
B. CONNECTION ACCESSORIES
7
Advertisement
