Events - Mastervolt CZONE Mac Plus User And Installation Manual

Events

A MasterBus device can be programmed to initiate an action at another connected device. This is
very helpful in automation of your system but is not required. In MasterBus this is done by means of
event-based commands. In the Events tab you can program the
source. Events which occur during the operation of the Mac Plus will then trigger actions from other
products.
Field
Event x source
Event x target
Event x command
Event x data
Mac Plus – User and Installation Manual
Meaning
Select an event that triggers an action, for example
Battery pre low.
Select the device that should take action, for
example the generator
Select the parameter that must be changed on the
target device, for example Activate.
Data translates the input into an output.
Input
On
Off
Copy
Copy
invert
Toggle
•
On: status changes to On at first input signal.
•
Off: status changes to Off at first input signal.
•
Copy: status follows input signal.
•
Copy invert: status follows opposite of input.
•
Toggle: status changes at 1
nd
at the 2 .
Mac Plus
st
signal and back
23
to act as an event
Value
See Event source list
Selectable targets are
system dependent
See command list of
the selected device
Off, On, Copy,
Copy Invert, Toggle