International registered trademark n. 2.777.971 IMPORTANT SAFETY INFORMATION GENERAL SAFETY PRECAUTIONS The following precautions are an integral and essential part of the product and must be supplied to the user Read them carefully as they contain important indications for the safe installation, use and maintenance. 1.
International registered trademark n. 2.777.971 GENERAL SAFETY INFORMATION An appliance shall be provided with an instruction manual. The instruction manual shall give instructions for the installation, operation, and user maintenance of the appliance. The installation instructions shall specify the need for a grounding-type receptacle for connection to the supply and shall stress the importance of proper grounding.
Page 4
As for misunderstandings that may arise refer to your area distributor or call our help desk. These instructions are part of the device and must be kept in a well known place. The installer shall follow the provided instructions thoroughly. SEA products must only be used to automate doors, gates and wings.
Page 5
International registered trademark n. 2.777.971 Changes to UL 325 ED. 6th for Gate Operators Starting on Jan. 12, 2016, new UL 325 changes take effect, bringing a series of new mandates for the gate operator industry. Here’s a quick guide to the key modifications. Entrapment-Protection Devices.
(fig. 10). Important: For a higher security, SEA advices to install infrared Fig. 8 photocells. Make sure that no person not belonging to the company somehow activates the automation or acts on it from the outside (fig.
International registered trademark n. 2.777.971 FEATURES AND SPECIFICATIONS The SATURN and the BOXER are motor reducers TECHNICAL DATA Boxer 1000 Boxer 2000 designed for the automation of sliding gates with grease Power supply 120 V (±5%) 50/60 Hz lubrication or in oil bath, depending on the versions. The...
International registered trademark n. 2.777.971 MECHANICAL INSTALLATION 4. FOUNDATION PLATE ANCHORAGE To install the foundation plate it is necessary to: Hole 1 4.1. Prepare a concret basement with the dimensions shown in Fig. 12 where the foundation plate and the anchor bolts will be concreted.
International registered trademark n. 2.777.971 7. GEAR RACK MOUNTING 7.1. Release the motor and open the leaf completely; 7.2. Fix on each gear rack element the support pawls with the appropriate lock screws, make sure to put them in the upper part of the hole (Fig.
International registered trademark n. 2.777.971 Mechanical limit switch Fig. 27 Fig. 23 Adjusting the trimmer for braking, placed on the electronic control unit, it is possible to make the gate stop on the Inductive limit switch desired position. 9. MAGNETIC LIMIT SWITCH Fig.
Page 11
International registered trademark n. 2.777.971 11. CLUTCH ADJUSTMENT (Where present) Sliding gate 11.1. Switch off electric power. MAX 10 mm 11.2. In order to adjust the clutch it is necessary to: Magnet - Act on the scrub screw “A” (Fig. 34) as follows: Limit sheet - Turning clockwise = less clutch sensibility/more thrust Rack...
15. NOTICE C l o s e O p e n SEA USA Inc. can not be deemed responsible for any damage or accident caused by product breaking, being damages or accidents due to a failure to comply with the instructions herein.
Page 13
PRICES: Prices are based on the Price List in force. Discounts and quotation from Sales Rep. and other selling branches must be approved by SEA. Prices are F.O.B SEA Warehouse in Miami and do not include shipments costs. SEA reserves the right to modify the price list at any time and provide notice to its sales network.
Need help?
Do you have a question about the Boxer 1000 and is the answer not in the manual?
Questions and answers