Installation Instructions - M&C TEC1 Series Operation Manual

Installation instructions

All relevant regulations regarding accident prevention and safety need to be met during installation and
operation of the pump.
Warning
Warning
Note
Warning
Warning
14
High voltage!
Working without disconnecting the power supply may cause an electrical
shock.
Disconnect power supply before any assembly, maintenance or repair
work. Secure the pump against accidental restart!
Protect yourself and others against contact to parts of the pump, e.g. elec-
trical connections, which may be still connected to a power supply. Protect
yourself and others against contact to moving parts of the pump. Protect
the pump against entering of water and particles.
Make sure to comply with the current safety regulations regarding the
sample gas used in the pump.
Install the pump in well ventilated rooms and away from heat sources to
prevent any heat accumulation.
For outdoor installation, install the pump in a protective housing. The
housing needs to provide protection against frost in winter, and ventilation
in summer. Avoid exposure to direct sunlight.
Pumps contain mechanically moving parts that can cause vibrations. In
order to avoid damage to the pump and peripheal components / facilities
and to minimize acoustic noise, appropriate vibration isolation must be
provided. M&C offers e.g. vibration control air springs to de-couple the
vibration source from the vibration-free environment.
Especially the connections of the sample gas lines to the pump head need
to be de-coupled.
The components, which will be connected to the pump, need to meet the
requirements of the pneumatic data of the pump. For details please refer
to the technical data sheet or manual.
Make sure to comply with the current safety regulations when connecting
the pump to the power supply.
Make sure to comply with the current safety regulations regarding the
sample gas used in the pump.
MP- 4.01 www.mc-techgroup.com