M&C TEC1 Series Operation Manual page 18

o Remove the adhesive tape and any surplus thermally conductive paste;
o Reconnect the tubing for gas and drain connections.
o Do not mix up the hose connections; gas outlet and gas inlet are marked with arrows.
•
Mounting the Duran glass heat exchangers please notice:
o Check the PTFE/Silicon locking Rings for damage. In assembly, the locking rings must have the
PTFE side facing the medium, Otherwise the required degree of sealing cannot be guaranteed;
o Tighten the red GL coupling rings hand-tight by turning them to the right.
18