Receipt Of Goods And Storage; Installation Instructions - M&C TEC1 Series Operation Manual

RECEIPT OF GOODS AND STORAGE

The TEC1 gas cooler is a complete pre-installed unit.
•
Please take the TEC1 gas cooler and possible special accessories carefully out of the packaging
material immediately after arrival, and compare the goods with the items listed on the delivery note.
•
Check the goods for any damage caused during delivery and, if necessary, notify your transport
insurance company without delay of any damage discovered.
The equipment should be stored in a dry, protected, and frost-free room.

INSTALLATION INSTRUCTIONS

The Series TEC1 Peltier Gas Cooler is designed for both wall mounting and panel mounting, both indoors and
outdoors when sheltered from direct sunlight and rain.
For operation, the TEC1 must be securely mounted in a vertical orientation. Proper condensate
and drainage function is only possible if the equipment is mounted correctly.
The cooler has 2 mounting taps on each end to mount the cooler on wall, rails or panel with qty
¼"
4, - 20 bolts.
When in use, the TEC1 cooler should be placed in an area well away from any heat emitting
sources. In order to prevent damage caused by an accumulation of heat, the air vents must be
clear at all times.
When the equipment is being used outside, ample protection against the effects of direct
sunlight and dampness must be provided. In winter, the equipment must only be used in frost-
free areas.
Unheated gas sample lines must be provided with slope down to the cooler. In that case pre-
separation of the condensate is not required.
Connect the heated sample line with sufficient thermal decoupling to the cooler.
11