Is Start, Is Interval - Delta A1500 Series User Manual

User Manual
A1500
AC Power Source
4. Change parameter to 200 by numerical key or knob rotating, then press
confirm the setting

3.5.6 Is Start, Is Interval

Both the parameter ranges for Is Start and Is Intervals are 0.0~1000.0 msec, these
parameters are used for the surge current measurement.
Figure shown below indicates the measurement of the surge current starting at Is Start after
output enabled, and measurement time is Is Interval:
For example：if Is Start = 500ms, Is Interval = 200ms, then Is measurement shown on main
manual is the maximum current measured between 500~700ms after output enabled。
Following processes demonstrate how to set Is Start = 500ms and Is Interval = 200ms：
Save
1. Press
26 │ www.deltaww.com
Current
Is
Is Start
Recall
Save Recall
or to move cursor to Is Start
▲ ▼
▲ ▼
Is Interval
Enter
Output
Time
to