General Information; Introduction; Key Features; Specifications - Delta A1500 Series User Manual

User Manual
A1500
AC Power Source

1. General Information

1.1 Introduction

This manual describes the specifications, installation and operation instructions of Delta
A1500 SERIES Programmable AC/DC Power Source. In this manual the term, AC/DC
Source, stands for Delta A1500 SERIES Programmable AC/DC Source.
The series of AC source is a high efficiency programmable ac power source, which provide
low distortion sinusoid AC voltage output and measurement. Stable voltage and frequency
are obtained through accurate digital calculation provided by DSP IC. Remote programming
is accomplished either by the GPIB bus or the RS-232C serial port.

1.2 Key Features

A. Configuration
• Local operation from the front panel keypad
• Protection against Over-power, Over-load, Over-temperature, and Fan-fail
• Fan speed controlled by output power
• Built-in isolation output relays
• Remote operation via GPIB or RS-232C interface
B. Input/output
• Selective output voltage ranges with full scale of 150V/15A and 300V/7.5A
• V, I, F, P, CF, PF, Ip, Is, VA, and VAR measurements
• Remote inhibit control
• AC ON/OFF, DC ON/OFF, FAULT OUT TTL output signal.
1.3 Specifications
The operation specifications of A1500 SERIES Programmable AC Power Source are
listed below. All specifications have been tested according to the standard of Delta test
procedures. All specifications are based on resistor load with remote sense connection,
under 25±2℃ unless specified otherwise.
Model
AC input
Rating Voltage
Voltage range
Frequency range
Surge Current
Maximum current
Power Factor
Efficiency
5 │ www.deltaww.com
DME-ACS1152B SERIES
100-240 V , single phase
90-254 V
47-63 Hz
100A Max.
22A Max.
0.98 Min.
78% typ. (Full load at 110Vac input voltage)