Local Operation; Introduction; Operation Through Keypad And Knob - Delta A1500 Series User Manual

User Manual
A1500
AC Power Source

3. Local Operation

3.1 Introduction

The AC source can be configured to operate in local or remote mode. The operation in
remote mode through GPIB controller or RS-232C will be described in Chapter 4. This
chapter describes the operation in local mode through the keypad on the front panel for
data entry and test. If remote control cable are not connected, the AC source is configured
for local operation after AC switch is on.
LCD panel will show the self-test message as below after AC switch is on.
Then will enter main manual setting page as below. Operator can set output voltage and
frequency for three phase.

3.2 Operation through Keypad and Knob

A1500 series provides a user-friendly programming interface by using the keypad on the
front panel.
Save
Press
▲
numerical and decimal point key or knob to set number, press
User can press
setting manual to make more detail setting from this page, or press
main manual.
15 │ www.deltaww.com
Recall
move cursor between voltage and frequency to make selection. Use
▼
Menu/
to enter screen as below: user can enter advanced parameter
Home
to confirm selection.
Enter
Menu/
again back to
Home