Table of Contents
Advertisement
Putting into operation
When using high pressure hose extensions take care that the max.
length of 20 m is not exceeded!
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
20
3.
For high pressure cleaners with hose
drum, however, it must be uncoiled
completely. Unwind high pressure
hose straight and without nooses. The
high pressure hose may leave signs of
abrasion on some floors. Alternatively,
please also find non-marking high
pressure hoses in our range.
4.
Tightly screw together high pressure
hose and safety trigger gun.
5.
Lance on to safety trigger gun.
6.
Screw together lance and
safety trigger gun pressure tightly.
Putting into operation
Check the water inlet sieve for damage. Do not operate the
high pressure cleaner without or with a damaged filter.
Be careful when using hot water!
When running your high pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high pressure
cleaner without safety gloves!
7.
Check water inlet filter for cleanliness
prior to putting the high pressure
cleaner into operation.
Manually unscrew plug-in coupling.
Take out the water inlet filter using
needle nose pliers and thoroughly
rinse it with clear water and clean
it with the other parts. If the sieve is
dirty, water can not get through and
pressure will not build up.
8.
Connect water hose to water inlet (mi-
nimum requirements; 5 m hose length,
cross-section ¾", 10 bar). The high pressure
cleaner may be connected to a water
mains (1-10 bar pre-pressure) with either
cold or hot water (up to 60 °C). The Profi
series provides the opportunity of suck-
ing in water out of a container (see
direct suction).
9.
Each time check oil level at the oil
dipstick prior to putting the high
pressure cleaner into operation.
(Take care that cleaner is in horizontal
position!) Oil level must reach until
the upper edge of marking "OK".
21
Advertisement
Table of Contents
