Table of Contents
Advertisement
Cleaning function
en
Water tank
Hot soapy water:
Clean with a dish cloth and rinse thoroughly to
remove residual detergent.
Then dry with a soft cloth. Leave the water tank to
dry with the lid open. Rub the seal on the lid until
dry.
Do not clean in the dishwasher.
--------
Notes
Slight differences in colour on the front of the
■
appliance are caused by the use of different
materials, such as glass, plastic and metal.
Shadows on the door panels, which look like
■
streaks, are caused by reflections made by the
interior lighting.
Enamel is baked on at very high temperatures.This
■
can cause some slight colour variation. This is
normal and does not affect operation.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
This does not impair the anti-corrosion protection.
Keeping the appliance clean
Always keep the appliance clean and remove dirt
immediately so that stubborn deposits of dirt do not
build up.
:
Warning – Risk of fire!
Loose food remnants, fat and meat juices may catch
fire. Before using the appliance, remove the worst of the
food remnants from the cooking compartment, heating
elements and accessories.
Tips
Clean the cooking compartment after each use. This
■
will ensure that dirt cannot be baked on.
Always remove flecks of limescale, grease, starch
■
and albumin (e.g. egg white) immediately.
Use the universal pan for baking very moist cakes.
■
Use suitable ovenware for roasting, e.g. a roasting
■
dish.
26
.Cleaning function
Y our appliance has the "Descaling" operating mode.
C l e a n i n g f u n c t i o n
You can use the "descaling" operating mode to remove
limescale from the evaporator.
Descaling
The appliance must be descaled regularly in order for it
to continue operating correctly.
There are several steps in the descaling programme.
For hygiene reasons, the descaling programme must
be run through completely so that the appliance can be
ready for operation again.In total, the descaling
programme runs for approx. 70-95 minutes.
Descale (approx. 55-70 minutes), then empty and
■
refill the water tank
First rinsing cycle (approx. 9-12 minutes), then
■
empty and refill the water tank
Second rinsing cycle (approx. 9-12 minutes), then
■
empty and dry the water tank
If the descaling process is interrupted (for example, due
to a power failure or because the appliance has been
switched off), you are prompted to rinse the appliance
twice after it is switched back on. The appliance cannot
be used until the second rinsing cycle has come to an
end.
The frequency with which the appliance must be
descaled depends on the hardness of the water used.
When only five more steam-assisted operations are
possible, or fewer, the appliance reminds you to
descale it with a message on the display. The number
of remaining operations is displayed after the appliance
is switched on. You can therefore prepare for the
descaling in good time.
Starting
Caution!
Risk of damage to the appliance: Only use liquid
■
descalers recommended by us for the descaling
programme. The time the product needs to work
during descaling depends on the type of descaler
used. Other descalers may damage the appliance.
Descaler order no. 311 680
Descaling solution: Do not allow any descaling
■
solution or descaler to come into contact with the
control panel or other surfaces on the appliance.
This damages the surfaces. If this does happen,
remove the descaling solution immediately with
water.
If you have used a steam-assisted operation
immediately before descaling, you must first switch the
appliance off so that the residual water is pumped out
of the evaporator system.
Advertisement
Chapters
Table of Contents
