Table of Contents
Advertisement
Rails
en
Enamel is baked on at very high temperatures.This
■
can cause some slight colour variation. This is
normal and does not affect operation.
The edges of thin trays cannot be completely
enamelled. As a result, these edges can be rough.
This does not impair the anti-corrosion protection.
Keeping the appliance clean
Always keep the appliance clean and remove dirt
immediately so that stubborn deposits of dirt do not
build up.
:
Warning – Risk of fire!
Loose food remnants, fat and meat juices may catch
fire. Before using the appliance, remove the worst of the
food remnants from the cooking compartment, heating
elements and accessories.
Tips
Clean the cooking compartment after each use. This
■
will ensure that dirt cannot be baked on.
Always remove flecks of limescale, grease, starch
■
and albumin (e.g. egg white) immediately.
Use the universal pan for baking very moist cakes.
■
Use suitable ovenware for roasting, e.g. a roasting
■
dish.
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
:
Warning – Risk of burns!
The rails become very hot. Never touch the hot rails.
Always allow the appliance to cool down. Keep children
away from the appliance.
Detaching the rails
Push the front rail forwards and up
1.
(fig.
).
!
Then move the whole rail slightly to the rear
2.
remove it
ƒ
(fig.
).
"
Clean the rails with
cleaning agent and a sponge. For stubborn deposits of
dirt, use a brush.
24
and detach it
‚
ƒ
and
‚
Inserting the holders
If the holders fall out when you remove the rails, these
must be re-inserted.
The holders at the front differ from those at the rear
1.
(fig.
).
!
Use the hook to mount the front holder at the top
2.
into the round hole
‚
it at the bottom, and straighten it
Use the hook to attach the rear holder into the upper
3.
hole
and push it into the lower hole
‚
Attaching the rails
When hanging the rails, ensure that the sloping edge is
at the top of the rail (see figure).
The rails fit both the left and right sides.
Mount the rear of the frame at the top and bottom
1.
and pull it forwards
ƒ
Then insert it at the front
2.
(fig.
).
"
, set it at a slight incline, attach
(fig.
).
ƒ
"
(fig.
ƒ
(fig.
).
!
‚
and push it downwards
).
#
‚
ƒ
Advertisement
Table of Contents
