Table of Contents
Advertisement
Available languages
Available languages
Installation
Oven Assembly
OPTIONAL FOLDING CONVEYOR
The folding conveyor assembly must be installed
from the electrical box side of the oven.
1. Unfold the right side of the conveyor.
2. Push the conveyor onto the conveyor support
angles.
3. Unfold the left side of the conveyor and contin-
ue to push onto the support angles.
NOTE: Push until the sprocket on the folding
conveyor is inside the electrical box.
See View A.
4. Install the drive chain around the drive motor
sprocket and the sprocket on the folding con-
See View A
Folding Conveyor
(shown without belt for clarity)
Sprocket
Locating
Pin
View A
Conveyor
Bracket
veyor. Pull the folding conveyor to tighten the
chain.
5. Secure the folding conveyor using the con-
veyor locating pin. Install the pin from the in-
side of the electrical box, through the convey-
or bracket and into the folding conveyor. See
View A.
NOTE: If the mounting hole cannot be lined up or
the chain is too loose, the drive motor will
need to be repositioned.
Figure 14
16
See View A
Advertisement
Table of Contents
