Table of Contents
Advertisement
Available languages
Available languages
8. Clean oven components as follows:
a.) Clean the conveyor, crumb pans, nozzles,
nozzle support bar, conveyor support
angles and the air plate with a hot water/
detergent mix. Rinse with clean water. For
difficult cleaning use a heavy duty de-
greaser or oven cleaner that is safe for alu-
minum.
b.) Clean the oven interior with an all purpose
cleaner or an oven cleaner that is safe for
aluminum.
9. Reassemble the oven. Be sure the nozzles are
installed in the correct order. See Figure 25.
NOTE: The closed front end of the nozzles are
marked with the nozzle part number.
( may be removed as one piece --- disassembled here for clarity)
M8862
M8862
M8862
M8862
Standard Conveyor Assembly
M8863
M8863
M8863
M8863
Maintenance
EVERY 12 MONTHS:
A factory authorized service person should:
1. Open and clean the inside of the control box.
2. Check and tighten all electrical connections.
3. Check conveyor drive chain for cleanliness,
proper lubrication and alignment.
If maintenance is required contact your local ser-
vice company, a factory representative or the
Blodgett Oven company.
See View A
Figure 25
33
Cleaning
2 holes
1 hole
M8862
M8863
Nozzle Identification
from front of nozzles
View A
Advertisement
Table of Contents
